Vital signs measuring device

This device is used to measure the condition of rescue forces present in the operation.

The measurable parameters are:

  1. Body surface temperature and ambient temperature
  2. Pulse rate
  3. Type of motor activity

To start the device, after ensuring that it is fully charged, you turn its key to the on position. When the device is turned on, the sensor light turns on and the device starts beeping. If the modules and sensors are healthy, the device will beep 3 times after about 10 seconds and 4 times after 20 seconds. Then it calibrates itself and after about 3 minutes and 30 seconds, it beeps again 6 times and sends the information received from the rescuer. During the calibration and registration of symptoms, the device beeps intermittently at the same time interval.

After calibration, fix the device on the shoulder with a shoulder strap, facing upwards so that the charging part and the sensors are facing the rescuer’s back.

Activate the interface software and connect the device with it.

Put one of the temperature sensors inside the clothes and fix it on the body with glue.

Place the other temperature sensor outside the clothing to measure the ambient temperature.

Move the pulse sensor near the neck or head on the pulsating points to detect the pulse (from the mobile software), then fix it with glue.

In this case, the rescuer’s information is transferred to the vital data capture software through the interface and can be tracked by the field commander. Each device has a unique code that is specific to each person.

How to use the vital signs measuring device of Milad Daru Company:

  1. After the operation, put the device in charging mode and charge it with a standard charger (mobile charger) for 2 hours and pack it.
  2. The device should be used under protective clothing, so it does not need to be decontaminated after the operation.
  3. Avoid hitting and pulling its sensor wires.
  4. If you use the device in a wet place, wrap the device completely in plastic and then use it.
  5. If you fail to record the heartbeat, the device can send the rest of the parameters.
  6. If the back of the device is returned, the device will be out of warranty and will not receive any service.